Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco 6500 Ports Usage Utility

Dear All,

I have a Cisco 6500 catOs Version 8.2(2), the rack where 6500 is placed is a disaster a lot of rj45 cables it seems like a jungle.

The 6500 has the following modules:

N2 WS-X6K-SUP2-2GE with WS-F6K-MSFC2

N1 WS-X6224-100FX-MT

N4 WS-X6248-RJ-45

N2 WS-X6248-TEL

I'd like to know which ports are in use in the modules WS-X6248-RJ-45, WS-X6248-TEL,there is some port usage statistics?

Thanks in advance, best regards.

Igor.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Cisco 6500 Ports Usage Utility

Hi,

You can use the "show mac" command to get total packets received/transmitted and "show mac utilization" to get the last 5 minute traffic rate.

HTH

Andrew.

5 REPLIES

Re: Cisco 6500 Ports Usage Utility

You could use SNMP to view the last time the port status changed. The OID is .1.3.6.1.4.1.3076.2.1.2.17.1.1.0

Tools such as Solarwinds Engineer Toolset make this much easier.

HTH and please rate.

Community Member

Re: Cisco 6500 Ports Usage Utility

Many thanks for your reply, the SNMP is a good way to approch the problem but require an additional software.

I 'd like to know if there is some utility in the CatOs to do this job.

Best regards,

Igor.

Re: Cisco 6500 Ports Usage Utility

Not that I know. There are free SNMP Managers out there too.

Re: Cisco 6500 Ports Usage Utility

Hi,

You can use the "show mac" command to get total packets received/transmitted and "show mac utilization" to get the last 5 minute traffic rate.

HTH

Andrew.

Silver

Re: Cisco 6500 Ports Usage Utility

187
Views
7
Helpful
5
Replies
CreatePlease to create content