Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CISCO 6513 Line card failure

We have a cisco 6513 chassis and it is filled with differnt FRUs.As it happened that due to power recycle one the module WS-X6748-GE-TX started to show FRU power failure . we tried to reset the module by hw-module command but it showed the following error % module 11 is operationally off (FRU-power failed).We plug and un-plug the module also but was not able to revive the module.

As per my understanding that somehow chassis wass not able to power the module after the power recycle .So my question is if there was power fluctuation why did the power supply not able to handle it rather than damaging the module .

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: CISCO 6513 Line card failure

I can confirm that we are facing a known hardware issue which is 
described in the following document:

CSCsb32574
Power Converter Failure causes 6748-GE-TX linecard to power down
http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&b
ugId=CSCsb32574



Your linecard is affected by this issue and therefore I would recommend you to replace it.

Hope that helps.

regards,
Varun

1 REPLY
Silver

Re: CISCO 6513 Line card failure

I can confirm that we are facing a known hardware issue which is 
described in the following document:

CSCsb32574
Power Converter Failure causes 6748-GE-TX linecard to power down
http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&b
ugId=CSCsb32574



Your linecard is affected by this issue and therefore I would recommend you to replace it.

Hope that helps.

regards,
Varun

1115
Views
0
Helpful
1
Replies