Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 7600: How to extract inner vlans from q-in-q vlan?

Hello.

I've got a 10GE trunk interface from our partner. One vlan (id 1149) that comes on this port is a q-in-q vlan carring four inner vlans. How can I extract them?

Current interface configuration:

interface TenGigabitEthernet3/4

description XXXXXXX

switchport

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1140-1150

switchport mode trunk

4 REPLIES
Cisco Employee

Re: Cisco 7600: How to extract inner vlans from q-in-q vlan?

Hi,

I am not sure I understand exactly.

But if you are receiving double tag traffic with 1149 as outer dot1q and let's say vlan x,y and z as inner vlan.

You need to select one output port to which you will send the traffic.

If this port is on a regular lan line card (any Ws-X67xx) for example you can configure that port as Dot1q tunnel port :

interface gig 1/1

description XXXXXXX

switchport

switchport mode dot1q-tunnel

switchport mode access vlan 1049

--> with that config we will remove vlan 1049 from each packet incoming on the ten gig int with vlan 1049 and sends only the inner vlan out on gig 1/1 for example.

config guide for dot1q tunneling is at : http://www.cisco.com/en/US/partner/docs/routers/7600/ios/12.2SR/configuration/guide/dot1qtnl.html

If your egress line card would be an Es-20, Es+ or sip-400, you may do the same with EVC config using service instances. Some info on service instance can be found in :

http://www.cisco.com/en/US/partner/docs/routers/7600/install_config/ES40_config_guide/es40_chap4.html

Roland

New Member

Re: Cisco 7600: How to extract inner vlans from q-in-q vlan?

Hi Roland,

Yes vlan 1149 used as outer dot1q and vlan 143,156,841 as inner vlan.

In my setup there's no ES20 card, so I have to follow your sugesstion with the output port. Thanks for configuration example!

Is there any possiblity to remove the outer dot1q vlan on 7600's SVI?

New Member

Re: Cisco 7600: How to extract inner vlans from q-in-q vlan?

Cisco Employee

Re: Cisco 7600: How to extract inner vlans from q-in-q vlan?

hi,

No on SVI on 7600 you cannot do that.

Actually you cannot even route a double tagged packet on an SVI.

if you only have LAN line card I fear you are limited to the dot1q tunnel access port.

Roladn

448
Views
0
Helpful
4
Replies
CreatePlease to create content