Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 7600 VLAN based QoS


I have Cisco 7600 router, switching traffic between two physical port and SVI interface for example.

Both physical ports in 'mls qos vlan-based' state.

Next I configured acl, class-map and policy-map:

ip access-list standard ACL_test

permit any

class-map match-all CM_test

match access-group name ACL_test

policy-map PM_test

class CM_test

police rate 70000000 bps

and applied it to VLAN SVI interface:

interface Vlan3

ip address

no ip proxy-arp

service-policy input PM_test

service-policy output PM_test


Accordingly to attached image, what input and output traffic flows will be limited to 70 Mbps?

Hall of Fame Super Silver

Re: Cisco 7600 VLAN based QoS

Hello Miksim,

>>With a PFC2, PFC QoS does not support VLAN-based QoS with DFCs installed.

•With a PFC3, PFC QoS supports VLAN-based QoS with DFC3s installed.

•With a PFC3, you can attach policy maps to Layer 3 interfaces for application of PFC QoS to egress traffic. VLAN-based or port-based PFC QoS on Layer 2 ports is not relevant to application of PFC QoS to egress traffic on Layer 3 interfaces.


my understanding is the following:

the sum of traffic rates exiting the SVI to other IP subnets is that of the rate.

policing inbound applies to the physical ports so sum of inbound rates on ports is limited to the rate value.

as a result of this hosts in vlan3 cannot transfer more then 70 Mbps to other IP subnets/Vlans.

Hope to help


New Member

Re: Cisco 7600 VLAN based QoS

Hello Giuseppe.

Thanks for an useful anwer!

Will wait in this topic for somebody else, who used this future in production environment.

CreatePlease to create content