We have a cisco 837 router setup to handle internet and a backup wan tunnel at a small remote office. We want to use the DMZ port in the 837 to put a wireless access point there so it would be seperated from our internal network. Inside LAN can get out to the internet fine and the site-to-site tunnel works fine, but wireless traffic cannot reach the internet. We can ping the dmz interface, but cannot access the internet. Attached is the config. Any suggestions.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...