Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 857 Error when implementing Firewall

Hi, I am in the process of setting up a Cisco 857 (12.4(15)T5), when trying to start the firewall via SDM or SDM Express I get the following error:

"class-map type inspect match-any sdm-cls-insp-traffic

Error detected at this command. Click OK"

Then the firewall config doesn't save, can anyone help me out with this please

Thanks,

Chris

3 REPLIES

Re: Cisco 857 Error when implementing Firewall

Hi Chris

Can you confirm on what feature set you are running out there in your router ?

have you tried configuring any other firewall policy rules in the router ?

is it possible to try this config line via cli and check out if you are getting any error message out of it ?

regds

Re: Cisco 857 Error when implementing Firewall

Hi Chris

Can you confirm on what feature set you are running out there in your router ?

have you tried configuring any other firewall policy rules in the router ?

is it possible to try this config line via cli and check out if you are getting any error message out of it ?

regds

New Member

Re: Cisco 857 Error when implementing Firewall

Feature Set: C850-ADVSECURITYK9-M

When in configuration mode via the cli it doesn't even recognise class-map as a command.

Thanks.

181
Views
0
Helpful
3
Replies