Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 857 - Hairpinning

How would I go about enabling hairpin routing?

I need the Cisco to take a packet from an internal device that's destined for the Di0 IP to be forwarded back internally according to the existing port forwarding rules.

No-one seems to know how, surely there's a guru out there that knows how to get it done!

(Current config attached)

2 REPLIES

Re: Cisco 857 - Hairpinning

try to make an loopback interface and make nat insdie

on this loopback make apply a route map the redirect matched traffic by an acl to use an exit interface in the set command statment

*not sure about it

but, good luck

if worked rate :)

New Member

Re: Cisco 857 - Hairpinning

I gave up, pulled the bloody Cisco out and put in an bridging modem, with an embedded solution behind it doing IPTABLES and PPPoE.

Problem solved.

Get your act together Cisco! That's 2 things I've found that the 800 series cannot do.

- Port forwarding ranges

- Hairpinning

151
Views
0
Helpful
2
Replies