You have a static nat statement (ip nat inside source static 192.168.0.2 184.108.40.206)
I dont see an int with this inside ip 192.168.0.2 as a result the ip nat inside soucrce static tcp 192.168.1.3 will be over ridded by the previous command and would never work this might explain why all access to public ip from outside fails as translation to inside ip is not valid try sh ip nat translations and sh ip nat statistics to very pls.
Hi Thanks for your reply, I've resolved this issue by resetting the router loading a bare minimal config and then creating the routes and configuring the firwall.
Didnt notice the IP that you pointed out in the config when i looke though, thanks alot.
Is there a way to forward 1723 VPN port to the server? i have done so and get verifying username and password but then get error 721 it's like the server is unable to communicate back to my client to verify.
Thats good that the nat is working as for vpn have you allowed gre traffic (ip 47) through the router as well as pptp something like (access-list 101 permit gre any any)for gre.
Also not sure if problem could be related to nat config as i have seen a few problems listing pptp passthrough with 800 series concerning 12.4 and various nat problems if i remember the pix (6.3) cannot do pptp pass through if outside int is running ppoe and nat overload.
Thats good news best if you will be using cisco gear again on a regular basis would be to "buy" from e-bay a 1601 router and 2900 switch and build your own lab but stay away from sdm ,pdm config maker etc as you wont get familiar with the cli this way .
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...