09-04-2010 01:05 PM - edited 03-06-2019 12:49 PM
I have an 871 wireless router (c870-advipservicesk9-m version 15.1) and the c2960 switch (c2960-lanbasek9-m version 12.2). I was wondering if i can use the 871 to route between vlans on the c2960. I need to have 7 vlans setup on the network but the 871 only supports 4 vlans in its database. I know I can create more than 4 vlans on c2960's database but I don't how or if it's even possible to route between those vlans using the 871.
Solved! Go to Solution.
09-05-2010 06:38 PM
Thanks for that.
09-05-2010 07:49 PM
Hi Lei,
Just tried IOS versions 12.4(15)XY5, 12.4(11)XW10, and 12.4(4)XC7 and all three 12.4 will support 2 VLANs.
It looks like only 12.3 will support 10 VLANs. Too bad.
09-05-2010 08:02 PM
Hi Leo,
Thanks for testing it out!
09-05-2010 08:49 PM
Thanks Lei.
09-08-2010 12:11 PM
Hey Leo,
Do you know if version 12.3 supports DMVPN? I'm not able to find that it does.
09-08-2010 04:13 PM
Hello,
12.3 supports DMVPN. You can check it through the following link:
www.cisco.com/go/fn
Regards,
NT
09-07-2010 02:34 PM
THANK YOU ALL!!!
You've been very helpful! I will look into downgrading to 12.3.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: