The WAN speed is yet to be confirm as this is a new implementation.Will there be any issus if the WAN speed is low beside traffic is bottleneck at the WAN side?
I want to make sure your WAN speed is less than the maximum capabilities of your router. I hate to see you buy a router only to realize you can't achieve the maximum bandwidth of your WAN because your router is deemed "too small".
Answer that question first before choosing the model of your router.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...