Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 881W to Watchguard XTM 2 series

Hello - I have a Cisco 881 W router connected on port fa4 (WAN) to my cable ISP. Behind that (LAN side) I have created a VLAN 50 on port fa1 that runs to a Watchguard (XTM 2 series) to the External port. From there things are running smoothly as I have an internal port on the Watchguard running to my Cisco 3550 switch out to 4 VLANs on the LAN side.

Cisco 881 router is governed by a different agency and the customer want there own control over what goes in and out of their network (thats what the

Watchguard is for). Is there a way to create a  static nat entry on the Cisco router to NAT to a public IP address so they can manage the Watchguard remotely and potentially set up their own site to site VPN's

Thanks -

gm

Everyone's tags (4)
2 REPLIES
VIP Super Bronze

Cisco 881W to Watchguard XTM 2 series

Hi,

Have a look at table-5 in this link.  NAT is supported with the Advanced security feature image.

http://www.cisco.com/en/US/prod/collateral/routers/ps380/data_sheet_c78_459542_ps380_Products_Data_Sheet.html

HTH

New Member

Cisco 881W to Watchguard XTM 2 series

Thanks for reply - I have the Advanced IP Services image. I have tried the statements below but its no working for me....the 10.0.50.1 is the external port on the Watchguard......

ip nat inside source static 10.0.50.1 74.94.67.???

ip nat source static 10.0.50.1 74.94.67.???

gm

782
Views
0
Helpful
2
Replies
CreatePlease login to create content