Configured a Cisco 887VA with ospf, everything functional.
However after a reboot of the router, now the ospf command is not visible in the command list and can't configure ospf. What is the issue?
edge-router-01(config)#router ? odr On Demand stub Routes ospfv3 OSPFv3 rip Routing Information Protocol (RIP)
edge-router-01#sh license Index 1 Feature: advipservices Period left: Life time License Type: Permanent License State: Active, Not in Use License Count: Non-Counted License Priority: Medium Index 2 Feature: advsecurity Period left: Life time License Type: Permanent License State: Active, In Use License Count: Non-Counted License Priority: Medium
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...