Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco Application Control (ACE) Error Message

When I am trying to configure sticky on a 6509 ACE blade, I get the following error.

jonoc-ace1/Prod-Banner-Portal(config)# sticky ip-netmask 255.255.255.255 address both MYSPECTRUM-HTTPS-sticky

Error: sticky resource not available

jonoc-ace1/Prod-Banner-Portal(config)#

Any ideas.

1 REPLY
Bronze

Re: Cisco Application Control (ACE) Error Message

The ACE received a packet from the offending MAC address on the specified interface, but the source MAC address in the packet is statically bound to another interface in your configuration. This could be caused by either be a MAC-spoofing attack or a misconfiguration. Check the configuration and take appropriate action by either finding

271
Views
0
Helpful
1
Replies
作成コンテンツを作成するには してください