12-20-2006 02:24 AM - edited 03-05-2019 01:25 PM
If connected this devices in autonegotiation mode they agree on 100M half duplex.
But I need full duplex operation.
When I put both ports in 100 full duplex the link doesn't come up....
What is the problem?
Is it an interopeation issue?
Please help.
Thanks.
12-20-2006 04:28 AM
which interface types on both devices you are trying to inter-connect?
12-20-2006 07:21 AM
Almost sounds like you are using mdix . I would turn off mdix on both sides if supported .Make both ports either auto or hardcode both to 100 full and use a crossover cable .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide