Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Catalyst 2948G-GE-TX Switch

I have a switch with no OS it originally had CatOS, but somebody was trying to put IOS on this switch and erased the image. There is nothing in nvram, no bin file, nothing. it does get to rommon prompt. Is it possible to download a catos image and place it on the switch from rommon? Do I have any options?

2 REPLIES
Purple

Re: Cisco Catalyst 2948G-GE-TX Switch

Follow the recovery procedures . It will allow you recover the switch from rommon.

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00800949c3.shtml#cat4k

Cisco Employee

Re: Cisco Catalyst 2948G-GE-TX Switch

Hi Friend,

Check this link and you will be out of trouble

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00800949c3.shtml#cat4k

Make sure you use the same subnet for the me1 interface as the tftp address.

HTH

Ankur

*Pls rate all helpfull post

718
Views
0
Helpful
2
Replies
CreatePlease to create content