Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco Catalyst 2950C 100BASE-FX - with Cisco 4500 GBIC

Hi,

I have the following switch at one end

Cisco Catalyst 2950C 24-24 10/100 ports and 2 fixed 100BASE-FX uplink  ports

connected via fiber to Cisco 4506 Module

WS-X4306-GBCatalyst 4500   Gigabit Ethernet Module, 6-Ports (GBIC)
WS-G54841000BASE-SX  Short Wavelength  GBIC (Multimode only)

with MM fiber.

Now my link is not coming up?

Do i need to put any additional commands to get the link up?

One side is 100 based FX while the other is GIG - GBIC .....will it be uncompataible?

Please let me know...

Nouman

5 REPLIES
Cisco Employee

Re: Cisco Catalyst 2950C 100BASE-FX - with Cisco 4500 GBIC

Fiber ports don't auto negotiate on speed. They must be match on both side.

Regards,

jerry

New Member

Re: Cisco Catalyst 2950C 100BASE-FX - with Cisco 4500 GBIC

Hi Nomy,

You have 1000 configured on the GBIC and 100 on the other side.

Try configuring the speed to have them communicate.

Sending you the link which will have the Gbic cards supported on your switch:

http://www.cisco.com/en/US/customer/products/hw/switches/ps708/products_tech_note09186a00800a7af7.shtml#cat2900http://www.cisco.com/en/US/customer/products/hw/switches/ps708/products_tech_note09186a00800a7af7.shtml#cat2900


HTH

RAHUL
New Member

Re: Cisco Catalyst 2950C 100BASE-FX - with Cisco 4500 GBIC


HI Nomy,

I sent you the link so that you can have the correct Gbic for your switch as g5484 works on 1000 and other gbic x2922 works on 100, this is the reason you are not able to get the link up.

Here is the link again:

http://www.cisco.com/en/US/customer/products/hw/switches/ps708/products_tech_note09186a00800a7af7.shtml#cat2900

Please let me know if there is anything else I can help you with .

Have a great day !!

Regards,

RAHUL

New Member

Re: Cisco Catalyst 2950C 100BASE-FX - with Cisco 4500 GBIC

Hi,

Thanks for the answers.....but i have already purchased the

WS-G54841000BASE-SX  Short Wavelength  GBIC (Multimode only)

the following GBIC for the 4500.....is there a way to make them work? even if they work on 100?

i have already purchased the hardware and need a solution or work around?

will putting a GIG to FE fiiber convertor on the 4500 will solve the issue?

Cisco Employee

Re: Cisco Catalyst 2950C 100BASE-FX - with Cisco 4500 GBIC

Hello,

The 100Base-FX and 1000Base-SX do not work together. One thing you could do is, if you have a spare RJ-45 port on the 4500 side, then you can use a 100Base-TX to 100Base-FX coverter.

http://www.cisco.com/en/US/docs/switches/lan/catalyst2955/hardware/installation/guide/hgcable.html#wp1039862

Hope this helps.

Regards,

NT

945
Views
0
Helpful
5
Replies
CreatePlease to create content