I'm not an everyday networking guy - but have been taksed with getting these ready for an install. Our firm has some "templates" we use to help me along bu thtey are fo rthe model without the "S" at the end. Firmware needs to be at 12.2 (58) SE2 for special reasons.
I have 4, two are to be Level 2, two are to be Level 3. Each has 24 ports, plus 2 RJ45 GIG ports and 2 Fiber Ports.
The Level 2's need to use the fiber to connect long distance to one unit.
- What shoult the trunking ports on these be? 23 & 24? Forget the 2 GIG prots for trunking as one is used for something else?
- What would be the time zone for California / Cisco wise?
There's a lot more questions on this - but this is my starting point. I apologize that I'm not up on this, hope you'll provide some slack / time :-)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.