I am about to help someone setup the QoS on a cisco catalyst 2960 switch so that VoIP is given preference. I am told that there is not web-based gui to work with on this device and that it all must be done through the serial port using iOS commands. Is this true? Where would I find instructions to do this? Thank you
class-map match-all AUTOQOS_VOIP_DATA_CLASS match ip dscp ef class-map match-all AUTOQOS_DEFAULT_CLASS match access-group name AUTOQOS-ACL-DEFAULT class-map match-all AUTOQOS_VOIP_SIGNAL_CLASS match ip dscp cs3 ! ! policy-map AUTOQOS-SRND4-CISCOPHONE-POLICY class AUTOQOS_VOIP_DATA_CLASS set dscp ef police 128000 8000 exceed-action policed-dscp-transmit class AUTOQOS_VOIP_SIGNAL_CLASS set dscp cs3 police 32000 8000 exceed-action policed-dscp-transmit class AUTOQOS_DEFAULT_CLASS set dscp default police 10000000 8000 exceed-action policed-dscp-transmit !! ip access-list extended AUTOQOS-ACL-DEFAULT permit ip any any
user access vlan and voice...STP...and:
srr-queue bandwidth share 1 30 35 5 priority-queue out mls qos trust device cisco-phone mls qos trust cos auto qos voip cisco-phone
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...