Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco Catalyst 3560G-24TS Question

HI Team,

Can you please confirm if "Cisco Catalyst 3560G-24TS" is a layer 3 switch or layer 2 switch.

After upgrading the IOS to advanced IP services i still could not see any options in Cisco DM to configure IPs on each port or IP on each VLAN.

Thansk Team

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: Cisco Catalyst 3560G-24TS Question

Yes it does intervlan routing , with ip base its static and RIP and eigrp stub i believe . With enterprise it will support all major routing protocols bgp,ospf,eigrp etc... Wish I could help you with the gui but not too many people use it in this forum . Most of us are CLI geeks :-)

5 REPLIES

Re: Cisco Catalyst 3560G-24TS Question

The 3560 is a layer 3 switch. Not familiar with the Cisco DM, but those can be configured by the CLI.

interface vlan 1

ip address 10.1.1.1 255.255.255.0

interface vlan 2

ip address 10.2.1.1 255.255.255.0

ETC....

HTH,

Mark

New Member

Re: Cisco Catalyst 3560G-24TS Question

Thanks, Can this also perform intervlan routing using its own routing table ?

We can not see this funsctionality in Cisco DM gui, Can we not achive this through the use of GUI ?

Regards

Purple

Re: Cisco Catalyst 3560G-24TS Question

Yes it does intervlan routing , with ip base its static and RIP and eigrp stub i believe . With enterprise it will support all major routing protocols bgp,ospf,eigrp etc... Wish I could help you with the gui but not too many people use it in this forum . Most of us are CLI geeks :-)

New Member

Re: Cisco Catalyst 3560G-24TS Question

Thanks, That resolved the issue

Re: Cisco Catalyst 3560G-24TS Question

Yes the switch is capable of doing inter-VLAN routing and run routing protocols. I have not used the GUI for the switch, so I am not familiar with it's capabilities. Here is a CLI configuration guide. I will try to see if there is one available for the GUI.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_40_se/configuration/guide/swcli.html

357
Views
0
Helpful
5
Replies
CreatePlease to create content