CISCO Catalyst 4510R

[soshomile]

Dear All;

i have CISCO Catalyst 4510R configured in my company. i just added WS-x4306-GB module. Fiber terminates in this modules. please help me how to monitor and check that module.

i will wait for your kind reply

[Amit Singh]

You can use " Show module " to check if module is working fine on the chassis.

What do you mean by monitor, Do you want to montior the traffic on the links. Please explain.

You can use SPAN for the same.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_2_31a/config/span.htm

HTH,

-amit singh

[soshomile]

Dear Amit;

Thank you very much for your kind reply;

i use "show module" it works fine. my another question is this;

how cuold we diagnose this module. using "sh module" command it shows that status that it exists. but is there any technique to check the connectivity issue, monitoring as well?

i will wait for your kind reply

[ankbhasi]

Hi Friend,

In general you can issue "sh logs" to find various messages and as per your requirement you can enable different logging levels.

Also see this link to check port status and connectivity

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_2_37s/config/connect.htm

For enviromental monitoring

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_2_37s/config/pwr_envr.htm

HTH

Ankur

*Pls rate all helpfull post