My question is about Configuring the Switch Temperature Alarms specifically for the 4948.
Other Cisco switches have detailed instructions on configuring the temperature alarms (alarm facility temperature primary/secondary high etc..) however the documentation for the 4948 does not show the same commands.
We need to be able to change the alarm thresholds for the primary temperature alarm. Can someone walk me thru this process?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...