Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Catalyst 500 series etherchannel not working

Hi,

Iam not able to configure etherchannel in catalst 500 series switch

I have created an etherchannel group and assigned the required ports into that group, I have connected a server on the other end.I am able to see that the etherchannel status is showing "In Use", but iam not able to ping the other end device.What could be the issue?

  • LAN Switching and Routing
3 REPLIES
New Member

Cisco Catalyst 500 series etherchannel not working

Hi Prajith,

What is o/p of show etherchannel summary.If it's SU then your etherchannel is up aand working.Please check whether you have assigned portchannel to required VLAN.There could be some other issue related to VLANs and ip addressing.

BRegards

Mukul

New Member

Cisco Catalyst 500 series etherchannel not working

Hi Mukul,

Thanks for the reply

The switch only supports GUI and I cannot take the CLI. However I can see the etherchannel status as "In Use".There are no Vlans configured in the switch, all the ports are in default vlan.

I have assigned the switchport role to the interfaces to be added in the etherchannel group and have configured etherchannel as per the below doc.

http://www.cisco.com/en/US/products/ps6545/products_configuration_example09186a00806da6c9.shtml

The status of etherchannel is "In Use". But I am not able to comunicate with the other end device.

New Member

Cisco Catalyst 500 series etherchannel not working

Show us the config of the interface. Is in access mode? Is in trunk?

147
Views
0
Helpful
3
Replies