Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Catalyst 500 series switch - telnet access problem

Dear Group members,

please guide me to solve my problem.

in my network 2950,2960,3750,3560 and 500 series switch exists, I know in other switches telnet is enabled but default, but as I come across the 500 catalyst switch, telnet is not enabled for this switch, but yes i have taken webaccess of this switch and tried to find out that telnet is made enabled or not, but didnt find any clue there.

so please tell me really telnet is disabled on 500 cata. switch or is there any other way we can make telnet enable on the same.

actually this project was run by some other team and we have taken hand over from them as reneval of AMC contract.

Regards,

JKD

1 REPLY

Re: Cisco Catalyst 500 series switch - telnet access problem

Yes, the Catlayst Express 500 series only have WEB management, there is no Telnet, SSH or console access possible. The CLI is sort-of still there as the WEB interface pushes CLI-like commands to it when you configure it, however there is no direct CLI access.

HTH

Andy

571
Views
0
Helpful
1
Replies