cisco catalyst clustering

[frede_frede]

Hi,

Its possible to access a cluster member with ssh? rcommand use telnet and I want to remove telnet from the network

Thanks

Fred

[frede_frede]

No one with this problem?

Thanks

Fred

[Seb Rupik]

Hi Fred,

You cannot access the members directly.

Once you have logged into the cluster master switch, issue the command 'rcommand' followed by the cluster members switch number:

rcommand 3

You can confirm the cluster members with:

show cluster members

cheers,

Seb.

[frede_frede]

Hi Seb,

Yes you are right, but the rcommand use telnet, it's possible to access the members with another command that uses ssh?

Cheers,

Fred

[Seb Rupik · Accepted solution]

Hi Fred,

According to:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750x_3560x/software/release/15.0_2_se/configuration/guide/swclus.html#wp1029143

...you can't

cheers,

Seb.

[frede_frede]

Hi Seb,

thanks anyway

Cheers,

Fred

[youcef1055]

Hi,

Once the members of the cluster have been added you can connect using ssh.

ssh cluster-member-ip-address

You can show the cluster memeber ip address by the following command.

show access-lists

Regards

Youcef