Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Catalyst IP DEVICE TRACKING

Hi to all,

I've enable ip device tracking on some ports with these commands

Switch(config)# ip device tracking

Switch(config)# interface fastEthernet 4/3 or Gigabitethernet 1/0/48  ecc

Switch(config-if)# switchport mode access

Switch(config-if)# switchport access vlan 1  (vlan name)

Switch(config-if)# ip device tracking maximum 5

Switch(config-if)# ip verify source tracking

Switch(config-if)# end

                  

Everything is working but I can enable only one by one port.

I would like to know if it's possible to enable ip device tracking on all ports of the switch at once

Thanks in Advance

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions

Cisco Catalyst IP DEVICE TRACKING

Can you apply using the interface range command? This will apply commands to all the interfaces defined.

interface range fas4/1 - 48

or

interface range gig1/0/1 - 48

1 REPLY

Cisco Catalyst IP DEVICE TRACKING

Can you apply using the interface range command? This will apply commands to all the interfaces defined.

interface range fas4/1 - 48

or

interface range gig1/0/1 - 48

1372
Views
5
Helpful
1
Replies
CreatePlease to create content