"ip dhcp use vrf" is to enable/disable the use of VRF configured on the interface receiving the DHCP packet by the IOS DHCP server code when making an allocation.
Since DHCP Relay does not store the incoming VRF info associated with incoming interface, address may be allocated from an address pool which is not associated with a VRF and as a result, clients may not get address from the right pool.
By default, it should be "no ip dhcp use vrf connected". If you don't use vrf, you don't need worry about this command. HTH.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...