Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco csr1000v

Hi. We have Cisco csr1000 virtual  router.

Here is sh ver:

CSR1000virtual#sh ver

Cisco IOS Software, IOS-XE Software (X86_64_LINUX_IOSD-ADVENTERPRISEK9-M),

Version 15.3(2)S2, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2013 by Cisco Systems, Inc.

Compiled Wed 14-Aug-13 11:21 by mcpre

IOS XE Version: 03.09.02.S

Cisco IOS-XE software, Copyright (c) 2005-2013 by cisco Systems, Inc.

All rights reserved.  Certain components of Cisco IOS-XE software are

licensed under the GNU General Public License ("GPL") Version 2.0.  The

software code licensed under GPL Version 2.0 is free software that comes

with ABSOLUTELY NO WARRANTY.  You can redistribute and/or modify such

GPL code under the terms of GPL Version 2.0.  For more details, see the

documentation or "License Notice" file accompanying the IOS-XE software,

or the applicable URL provided on the flyer accompanying the IOS-XE

software.

ROM: IOS-XE ROMMON

CSR1000virtual uptime is 2 days, 20 hours, 31 minutes

Uptime for this control processor is 2 days, 20 hours, 32 minutes

System returned to ROM by reload

System image file is "bootflash:csr1000v-packages-adventerprisek9.03.09.02.S.153-2.S2"

Last reload reason: Reload Command

cisco CSR1000V (VXE) processor with 1141147K/6147K bytes of memory.

Processor board ID 9BLOBULI27O

2 Gigabit Ethernet interfaces

32768K bytes of non-volatile configuration memory.

4194304K bytes of physical memory.

7774207K bytes of virtual hard disk at bootflash:.

Configuration register is 0x2102

We want to issue following commands:

radius-server vsa send accounting

radius-server vsa send authentication.

After issuing this sommands we can't see them in running config.

What can be the problem?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Cisco csr1000v

Hello Ruslan,

From the output we can see both commands are enabled by default, that's the reason you don't see it in a running config via regular "show running-config" command.

Starting 15.3(1)S onwards both commands are enabled by default.

-- 
Best regards,
Dmitry Skotnikov

-- Best regards, Dmitry Skotnikov
4 REPLIES
Cisco Employee

Cisco csr1000v

Hello Ruslan,

Would you be so kind to capture the following output:

# show run all | i vsa

Thank you

-- 
Best regards,
Dmitry Skotnikov

-- Best regards, Dmitry Skotnikov
New Member

Cisco csr1000v

sh run all | include vs

device-sensor notify new-tlvs

radius-server vsa send cisco-nas-port

radius-server vsa send accounting

radius-server vsa send authentication

Cisco Employee

Cisco csr1000v

Hello Ruslan,

From the output we can see both commands are enabled by default, that's the reason you don't see it in a running config via regular "show running-config" command.

Starting 15.3(1)S onwards both commands are enabled by default.

-- 
Best regards,
Dmitry Skotnikov

-- Best regards, Dmitry Skotnikov
New Member

Cisco csr1000v

Thanks !

217
Views
0
Helpful
4
Replies
CreatePlease to create content