Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CISCO INSTANT ACCESS SOLUTION

Hello

 

I have a 6807XL Switch, and I want to migrate to Instant Access solution, which 10 Gbps Line Cards must I buy

WS-X6904-40G-2T  or  WS-X6816-10G-2T

In order to the Cisco 6800IA can joint to the 6807??

Regards

 

Rafael Barba

 

3 REPLIES

According to the Q&A it is

According to the Q&A it is the WS-X6904-40G-2T

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-6800ia-switch/qa_c67-728684.html

 

Q.    What are the different components of the Instant Access solution?
A.     The Instant Access solution requires new Cisco Catalyst 6800ia Instant Access clients and Cisco Catalyst 6500 or 6800 Series Switches (Instant Access parents) with Supervisor Engine 2T and WS-X6904-40G-2T line cards. Instant Access requires Cisco Catalyst 6500 or 6800 Series Switches configured for Virtual Switching System (VSS) mode, and we recommended having a pair of switches to provide the maximum level of redundancy and load balancing. Note: In networks where a pair of Cisco Catalyst 6500/6800 is not available, a single Cisco Catalyst 6500/6800 switch may be used when configured for VSS mode.

New Member

Hello FriendThank you for

Hello Friend

Thank you for your answer, I see that the Q&A is recomending me the WS-X6904-40G-2T , but what happend if I have the line card WS-X6816-10G-2T the Instant Access should be works??, or is there some kind of limitation with it line card (WS-X6904-40G-2T )???

 

Regards

Rafael Barba

As far as I know only the

As far as I know only the 6904 is supported at this time. There should be new line cards coming out soon so that might change.

112
Views
0
Helpful
3
Replies