I a brand new 3750 Cisco switch, my co-worker is sending the configuration for the switch. How would I take the config my co-worker is sending and copy it the new switch?
The 3750 is a different beast. What are you doing with the 3750? Are you installing a new switch or are you adding the 3750 to an existing stack? If you are installing a new switch then the command "copy tftp://config.text flash:" or "copy tftp://config.text run" will be suffice.
If you are adding the 3750 into an existing stack, just rack mount the switch (do NOT power up the switch as of yet), stack the cables and finally power up the 3750.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.