We have sevral 2950s I recently upgraded IOS and configed to only permit SSH. Since security is the concern, I also did 'no ip http server'. Unfortunately now Cisco Network Assistat does not work (no SSL on that IOS).
Once "transport input ssh" in placed under the VTY lines, there is no access to the http server. Is there a way to only allow SSH on the lines but also allow the web server interface to be active, besides allowing telnet sessions?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...