Cisco Nexus 6004 switch drops IP packets greater than 300 bytes
We have a Level 3 10G wave circuit running in between two Cisco Nexus 6004 switches. The circuit came online between our two data-centers (in the same city) without a problem.
When we attempt to ping the remote-end's 10G interface, it works fine with 64byte packets. CDP is enabled and we can view the remote switch CDP information. However, if we increase the size of the ping packets to upwards of 300 bytes, we lose 1 in every 20.
We verifed MTU settings, 10G cable type, and duplex settings.
Level 3 has tested clean and we are going forward with more tests.
Any ideas as to the problem? We are having the carrier come out and test end-to-end with their testers. But so far, the circuit is testing clean. I wasn't sure if this is something Cisco related. I'm at a loss at the moment.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.