04-14-2014 06:51 AM - edited 03-07-2019 07:05 PM
Hi all,
Hi have install a cisco nexus 7010 with the following modules :
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
1 48 1000 Mbps Optical Ethernet XL Modul N7K-M148GS-11L ok
2 48 10/100/1000 Mbps Ethernet XL Module N7K-M148GT-11L ok
5 0 Supervisor Module-2 N7K-SUP2 active *
6 0 Supervisor Module-2 N7K-SUP2 ha-standby
9 48 10/100/1000 Mbps Ethernet XL Module N7K-M148GT-11L ok
10 48 1/10 Gbps Ethernet Module N7K-F248XP-25E ok
After trying to build a port-channel with a 1G port on slot 1 and a 1G port on slot 10 i get a messague with incompatible port.
Can any one tell me if its supported a port-channel with ports on the following modules :
N7K-M148GS-11L
N7K-F248XP-25E
Thanks
Patrício
Solved! Go to Solution.
04-14-2014 07:54 AM
Hi Particio,
The port-channel/vPC features require that all uplinks are connected to the same type of
module. You can refer to the following document.
http://www.cisco.com/en/US/partner/docs/switches/datacenter/sw/6_x/nx-os/interfaces/configuration/guide/if_portchannel.html#wp1888267
HTH
Regards
Inayath
*Plz rate if this is helpfull and mark as Answerd if this answerd your query.
04-14-2014 07:43 AM
Hi Patricio,
According to the docs:
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/interfaces/configuration/guide/if_cli/if_portchannel.html#wp1798353
Ports from these line cards will no be able to join the same port-channel becuase of a '(Link) speed capability' mis-match (1000 vs 1000/10,000).
cheers,
Seb.
04-14-2014 08:08 AM
Hi All,
After searching i found that is not possible to bundle interfaces from M1-XL and F2 module
thanks to all,
Patricio
04-14-2014 08:12 AM
Hi Patricio,
If our answer helped you could you please do a favour of marking the rating and select the option of Correct Answer so that we close this thread?
thanks in advance.
REgards
Inayath
04-14-2014 07:54 AM
Hi Particio,
The port-channel/vPC features require that all uplinks are connected to the same type of
module. You can refer to the following document.
http://www.cisco.com/en/US/partner/docs/switches/datacenter/sw/6_x/nx-os/interfaces/configuration/guide/if_portchannel.html#wp1888267
HTH
Regards
Inayath
*Plz rate if this is helpfull and mark as Answerd if this answerd your query.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: