Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Nexus 7010 Port-Channel

 

Hi all,

 

Hi have install a cisco nexus 7010 with the following modules :

 

Mod  Ports  Module-Type                         Model              Status
---  -----  ----------------------------------- ------------------ ----------
1    48     1000 Mbps Optical Ethernet XL Modul N7K-M148GS-11L     ok
2    48     10/100/1000 Mbps Ethernet XL Module N7K-M148GT-11L     ok
5    0      Supervisor Module-2                 N7K-SUP2           active *
6    0      Supervisor Module-2                 N7K-SUP2           ha-standby
9    48     10/100/1000 Mbps Ethernet XL Module N7K-M148GT-11L     ok
10   48     1/10 Gbps Ethernet Module           N7K-F248XP-25E     ok

 

After trying to build a port-channel with a 1G port on slot 1 and a 1G port on slot 10 i get a messague with incompatible port.

 

Can any one tell me if its supported a port-channel with ports on the following modules :

 

N7K-M148GS-11L

N7K-F248XP-25E

 

Thanks

Patrício

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi Particio,The port-channel

Hi Particio,

The port-channel/vPC features require that all uplinks are connected to the same type of
module. You can refer to the following document.
http://www.cisco.com/en/US/partner/docs/switches/datacenter/sw/6_x/nx-os/interfaces/configuration/guide/if_portchannel.html#wp1888267

 

HTH

Regards

Inayath

*Plz rate if this is helpfull and mark as Answerd if this answerd your query.

 

 

4 REPLIES

Hi Patricio,According to the

Hi Patricio,

According to the docs:

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/interfaces/configuration/guide/if_cli/if_portchannel.html#wp1798353

 

Ports from these line cards will no be able to join the same port-channel becuase of a '(Link) speed capability'  mis-match (1000 vs 1000/10,000).

 

cheers,

Seb.

New Member

 Hi All, After searching i

 

Hi All,

 

After searching i found that is not possible to bundle interfaces from M1-XL and F2 module

 

thanks to all,

Patricio

Cisco Employee

Hi Patricio,If our answer

Hi Patricio,

If our answer helped you could you please do a favour of marking the rating and select the option of Correct Answer so that we close this thread?

 

thanks in advance.

REgards

Inayath

 

Cisco Employee

Hi Particio,The port-channel

Hi Particio,

The port-channel/vPC features require that all uplinks are connected to the same type of
module. You can refer to the following document.
http://www.cisco.com/en/US/partner/docs/switches/datacenter/sw/6_x/nx-os/interfaces/configuration/guide/if_portchannel.html#wp1888267

 

HTH

Regards

Inayath

*Plz rate if this is helpfull and mark as Answerd if this answerd your query.

 

 

87
Views
0
Helpful
4
Replies
CreatePlease login to create content