Recently I have upgraded to latest image file i.e 15.1(2) T1 to support the Ipv6 functionality in my router. It seems that Cisco will support only CISCO-IETF-IP-MIB instead of standard Mibs IP-MIB (RFC4293). Please let me know the reason why Cisco didn't support the standard mibs. If it is in the Internet Draft standard, there is no problem. But the IP-MIB (RFC4293) will be in standard track from 2006.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...