Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco rsm Intelligent switch module-corrupt image?

My rsm module on Cat 5500 has gone into boot mode. There is nothing in slot0: and when I try to copy fron tftp into slot0: it gives the error message "File Table Overflow" and when I try and copy it into the booflash it says not enough space... I did notice that my new IOS image size is much bigger than the total space on bootflash (including used)..Currently the bootflash has an image in it but I dont know why its in boot mode. I changed the config reg value to 2102 and restarted but it stuck in boot mode..Can some explain to me whats going on and how can I recover from this?

3 REPLIES
Purple

Re: Cisco rsm Intelligent switch module-corrupt image?

Can you post a "dir bootflash and dir slot0: , also a "show boot" command .

New Member

Re: Cisco rsm Intelligent switch module-corrupt image?

rsm-FQDN(boot)#dir bootflash:

Directory of bootflash:/

1 -rw- 3960504 Jan 01 2000 00:44:40 c5rsm-boot-mz.120-10.W5.18a.bin

7602176 bytes total (3641544 bytes free)

rsm-FQDN(boot)#dir slot0:

%Error opening slot0:/ (No device available)

rsm-FQDN(boot)#show bootvar

BOOT variable = c5rsm-boot-mz.120-10.W5.18a.bin,1;

CONFIG_FILE variable does not exist

BOOTLDR variable does not exist

Configuration register is 0x2102

New Member

Re: Cisco rsm Intelligent switch module-corrupt image?

I figured it out.. Someone had removed the PCIMCA card from slot0: thats why it was booting off of the boot helper image in boot flash!! Once the put the card back it..it worked fine...

205
Views
0
Helpful
3
Replies
CreatePlease to create content