cisco SGE2010p Setup DMZ, 1 guest and 1 Private VLAN
I have a CISCO SGE2010p, UC560, 2811 in my environment and I would like to create the following senario but unsure on the best potential approach.
1 DMZ (SERVERS) VLAN10
1 GUEST (Internet only) VLAN20
1 PRIVATE (Desktops) VLAN1
1 VOICE (UC Network) VLAN100
I would like the SGE2010p to handle the local routing to reduce the workload of the 2811 which has 3 internet connections 2 DSL and 1 Ethernet, I was thinking of having the DMZ Static and on the same subnet as the router, I only want the UC to handle VOICE however we are using passthrough for our 7965 handsets and the guest network connects up via a cisco SRW2048 which I only want to see the GUEST VLAN.
Dont want the VLANS to talk except the DMZ etc where required.
Does anyone have some config advice or examples they could share.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...