Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco SLM2008T and SLM2016T / WAP 4410N - IPV6 support

Hi ,

I am planing to have a smalll IPV6 setup for SMB based company ( 30 Users) , they are very keen on Budget , so i have choosen some of the smart switches whoc supports IPV6 (as per the cisco sites) .

Cisco SLM2008T and SLM2016T - Switches

Cisco WAP 4410N - access point

Can anyone advice on , whether this products are capable to run IPV6 (very minimal IPV6 data transfer rate required) ,?

Do anyone have any experince on using these products ? How is the performance ?

Is there any alternatives in cisco produst series with same cost. ? ( Dont want to go for catalyst series)

Does the Wireless AP is capable to transport IPV6 traffic ?

Any input or comments are welcomed.

Br.,

sakthi

Everyone's tags (4)
533
Views
0
Helpful
0
Replies