Scenario is that VSS is established between two 6500 with single SUP in each chassis but each chassis located in different DC and VSL is established via 10Gig link. My question is that for the following dual active detection mechanism, can we use indirect link via switch over a VLAN:
Never done it using a LAN switch, and I don't think once you enable fast hello on the ports you can issue any other command like configuring them as access ports and adding them to a vlan. If it does not work, you can always use a fiber port with 2 single mode optics and connect them back to back.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...