Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Cisco WFQ QOS show queue

Hello

Just been reading some documentation on WFQ and was woundering how you see the active flows/Queues. I have seen output examples from the show queue command that show active flows. When I have been trying the command on 12.4 it only shows me details about the queue lengths.

12.3(8r)T7 show queue output:

show queue s0/3/0
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 1207
  Queueing strategy: weighted fair
  Output queue: 0/1000/64/1202 (size/max total/threshold/drops)
     Conversations  0/71/256 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
     Available Bandwidth 1536 kilobits/sec

 

Thanks

James

  • LAN Switching and Routing
Everyone's tags (1)
1 REPLY
Super Bronze

DisclaimerThe Author of this

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting


My experience has been not all IOS versions will show FQ flows.  Some do, though.  They will be listed under your summary stat, with information how many packets in that flow queue and some information about the 1st packet in the queue.

 

To see the flow queues, you need to have packets queued at the time you issue the show command.  In your example, your total output queue shows zero, so you wouldn't see any flow queue.

30
Views
0
Helpful
1
Replies
This widget could not be displayed.