Cisco WS-C2980G-A only shows 10/100 yet claims Gigabit?
Hello, we have a very old WS-C2980G-A that I'm trying to configure.
It says on the front it is Ethernet 10/100/1000, but when I see port speeds it only goes to 10/100 and 1000 is not an option in the IOS.
I've looked at the manual and its going over gigabit ethernet and flow control settings, but when I try to turn on flow control or make any changes, it says that feature is not available on this port. (
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...