Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CISCO WS-C3560G-48TS Ports 1-48 not negotiating 1000M with neighbor switch

We have two switches CISCO WS-C3560G-48TS in our network. When we connect these two switches via cross cable through any of the ports (1-48) and trying to hard code the speed on both sides as 1000M, interface is going down physically. We have enabled dot1Q trunking. Link is working fine with 100M/Full duplex settings. But not working with 1000M speed. Is this an expected behaviour of ports 1-48 (non SFP ports)? SFP Ports are working fine with 1000M/Full. Please suggest.

2 REPLIES
Hall of Fame Super Silver

Re: CISCO WS-C3560G-48TS Ports 1-48 not negotiating 1000M with n

Hello Michael,

first of all the switches may support MDXI that is the capability to adapt to the cable type.

If a crossover cable is needed or used it has to be of a special type:

1000 Mbps over UTP uses 4 pairs not 2 pairs so a cable that crosses 1,3 and 2,6 is not enough to get a GE link

see

http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/css11500series/v7.50_v7.40/installation/guide/Pinouts.pdf

pag 8

Hope to help

Giuseppe

New Member

Re: CISCO WS-C3560G-48TS Ports 1-48 not negotiating 1000M with n

Hi Giuseppe,

Thanks for the lightning response.You mean to say that four twisted-pair Cat5e cable is required to establish back-to-back switch connectivity that supports 1000M speed. We cannot achieve this connectivity using normal cat5 cable.

Thanks and Regards,

Manjesh Michael

197
Views
0
Helpful
2
Replies