I am using 6509 Switch installed with WS-X6748-SFP module. I used the command "show interface gigabitethernet 1/1 capablities". I am seeing a lot of stuffs in the output. One thing which interested me is "Ports-in-ASIC (Sub-port ASIC)" information. Find the attached command output file.
"On switches a lot of port hardware is based on asics which control 4-8 ports on a slot . Each of the asics has a certain amount of bandwidth to the backplane of the switch . If a asic has a 4 gig backplane bandwidth but there 8 1 gig ports on that asic then those group of ports are oversubscribed for those given ports . This is only an issue if you get more than 4 of those connections running a full gig and is what cisco bets on when designing their switches this way ." . In your case you should try to see (or maybe some expert can give us this info) whats the bandwith of the connection to the backplane in that module to see how much oversubscrition there is
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...