Recently implemented branch office with cisco2811 router with vwic-1mft-g703 configured for 1-31 timeslots. And the symptom is that the wan link connected tothe g.703 port goes off and back on automatically about the same time everyday.
Appreciate any lead on troubleshooting this issue and specifically on g.703 links
In addition to Narayan's post,I would suggest to do the local and remote loop testing when this problem happens. Talk to your telco and try to get them involved in the loopback testing. If test the local loop i.e from telco's MUX to your router end.If that's fine then check the remote loop from the far-end mux and check if still the problem is there.If yes,could be a media problem from Telco's end.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...