Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cisco2921 g0/1 udld support?

Hi guys,

Does g0/1 port (dual purpose port but set to use sfp) support udld? If yes, what's the command to enable it? I have it connected with a 3750v2 switch. On the switch I have udld enabled.

Thanks,

Difan

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

cisco2921 g0/1 udld support?

Hello Difan,

UDLD is a typical switch feature so I would not expect to see it supported on a router built-in interface.

It may be supported on an HWIC etherswitch module but not on the built-in ports.

On the other hand, C3750 does not support BFD that could have been an alternate solution for rapid convergence

see

http://www.cisco.com/en/US/docs/ios-xml/ios/iproute_bfd/configuration/12-4t/Bidirectional_Forwarding_Detection.html

Feature navigator shows only ME3600, ME3800 and C6500 with sup720 as switches supporting BFD

FN shows only switches inclusing C3750 for UDLD feature

http://www.cisco.com/go/fn

search by feature

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

cisco2921 g0/1 udld support?

Hello Difan,

UDLD is a typical switch feature so I would not expect to see it supported on a router built-in interface.

It may be supported on an HWIC etherswitch module but not on the built-in ports.

On the other hand, C3750 does not support BFD that could have been an alternate solution for rapid convergence

see

http://www.cisco.com/en/US/docs/ios-xml/ios/iproute_bfd/configuration/12-4t/Bidirectional_Forwarding_Detection.html

Feature navigator shows only ME3600, ME3800 and C6500 with sup720 as switches supporting BFD

FN shows only switches inclusing C3750 for UDLD feature

http://www.cisco.com/go/fn

search by feature

Hope to help

Giuseppe

New Member

cisco2921 g0/1 udld support?

Thanks as always Giuseppe

328
Views
0
Helpful
2
Replies