Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

[Cisco3560x]Ping PC is destination unreachable

I have topology like :

Core 3560x ---------------------- Baseline Switch Manage 2924 ------------------ Switch Unmanage ------------------ AP ------------------ Client (A) (B)

 

Vlan 2 = 192.168.2.x/24

Vlan 3 = 192.168.3.x/24

 

If client A have ip address 192.168.2.2/24 gateway 192.168.2.1

and client B have ip address 192.168.2.3/24 gateway 192.168.2.1

Client B can ping client A but result is destination unreachable

Client A can ping gateway in core 3560x the same client B

But if client C in switch manage with vlan 3, client C can ping client A and the result is reply.

 

what happened?

please help me,thanks before, sory for bad my english.

 

7 REPLIES
Cisco Employee

Core 3560x ------------------

Core 3560x ---------------------- Baseline Switch Manage 2924 ------------------ Switch Unmanage

 

Whats the port config connecting between core and base line?

are the ARP learning on th core?

 

New Member

Can you execute show arp on

Can you execute show arp on every switch  and verify where the ip address 192.168.2.2 is not associated with the mac address

New Member

port config connecting

port config connecting between core and baseline is switchport trunking encap dot1q, switch mode trunk...

 

 

Cisco Employee

 If i understand it correctly

 

If i understand it correctly, client A can ping client C which is in different subnet/vlan but can not ping client B which is in same subnet. Please provide config of switch where client A,B are connected. Is there any port security applied. And show arp also from client A and B.

 

Regards,

Akash

New Member

Yes...Client A to client C

Yes...

Client A to client C can ping in different subnet.

Client A to client B can not ping in same subnet..

Client C to client B can ping in different subnet..

but is Client D same with subnet client C can ping..

Sometimes reply sometimes destination unreachable..

 

if i traceroute from core to client B is timeout

but i ping from core to client B is reply...

 

Please advice...

Cisco Employee

Please check Windows Firewall

Please check Windows Firewall on the PC's and then work upwards on the network level if Windows FW/Anti-virus and any other security softwares are disabled.

New Member

firewall windows n AV is

firewall windows n AV is disabled. Not other security software.

123
Views
0
Helpful
7
Replies