01-16-2008 12:25 PM - edited 03-05-2019 08:31 PM
Hello everybody,
I'd like to know why ciscoview doesn't match their up/down GUI ports on the Sw-2960 series with the CLI command "sh interface status". There must be a problem because ciscoview shows even the uplink ports down when they obviously are up!
01-21-2008 08:09 AM
I'am using the following ciscoview version: 6.1.5
01-21-2008 01:32 PM
You might do better to post this in the Network Management forum. Most discussions about Ciscoworks and Ciscoview are in there.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide