Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

clear config - interface

hi! what's the command to clear an gigaethernet internface config on a 4506e sw? currently there are lots of qos and security stuffs on some of the gigaethernet port. instead of using the no command for each of the line, is there a command to clear all these config? i just want to configure access vlan on the port.

thx.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: clear config - interface

You can try to use below command on the configuration mode....

xxx-xxx(config)#default interface gigabitEthernetx/x - specify the port that you would like to clear the configuration...see whether it works or not.

And let me know later

3 REPLIES
New Member

Re: clear config - interface

You can try to use below command on the configuration mode....

xxx-xxx(config)#default interface gigabitEthernetx/x - specify the port that you would like to clear the configuration...see whether it works or not.

And let me know later

New Member

Hi there,

Hi there,

I tried the above command and it works.

Thanks,

New Member

Worked for me too, thanks!

Worked for me too, thanks!

73998
Views
10
Helpful
3
Replies