Switchport showing up and reset the switchport still it's down and cleared the counters on interface no luck. I would like to clear interface int-ID clear hardware logic how it will effect and is it solves the issue.
To reset an interface, enter into interface configuration mode and issue the 'shutdown' and 'no shutdown' commands. This will bring the interface down then up like as you would reconnect the cable physically.
Switch# conf term
Switch(config)# interface FastEthernet0/1
Switch(config-int)# no shutdown
To clear the interface counters, use the 'clear counters FastEthernet0/1' command or 'clear counters' to reset the counters on all interfaces.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.