Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

cco
New Member

CLI equivalent commands for Smartport Roles

Hi,

I wonder if anyone was able to find any kind of reference or document for the CLI equivalent commands for the GUI smartport roles on the cisco catalyst 500 express switch? I have searched a lot but didn't find anything.

Thanks in advance,

5 REPLIES

Re: CLI equivalent commands for Smartport Roles

Cisco catalyst 500 series do not support CLI

From the FAQ

http://www.cisco.com/en/US/products/ps6545/products_qanda_item0900aecd80322b09.shtml

Narayan

cco
New Member

Re: CLI equivalent commands for Smartport Roles

Thanks for the reply. Yes I know that the Cisco catalyst 500 series do not support CLI. In other words, my question is: what are the (equivalent) set of command(s) applied on the 500 switch when applying a certain smartport role to the switch port using the GUI?

cco
New Member

Re: CLI equivalent commands for Smartport Roles

Well I'm asking because knowing the exact configuration applied using the smartport roles will help us in troubleshooting connectivity issues for the 500 series switches.

New Member

Re: CLI equivalent commands for Smartport Roles

You may try the following:

http://10.10.10.10/exec

Use this where 10.10.10.10 is the ip of your catalyst express switch. This sort of allows you to issue cli-like commands to the switch, and allows you to see what the configuration is. I'm not sure if this will help or not. What you can actually do here is also very very limited.

New Member

Re: CLI equivalent commands for Smartport Roles

That was very helpful. Thanks for the info

148
Views
5
Helpful
5
Replies