Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

clns routing

could someone explain the below command to me... thanks:

<br />

<br />mpls ldp neighbor 192.x.x.1 password 7

<br />mpls label protocol ldp

<br />no issu config-sync policy xxx xxx

<br />issu config-sync policy xxx xex

<br />

2 REPLIES

Re: clns routing

mpls ldp neighbor 192.x.x.1 password 7

This command configures a passowrd with the LDP neighbor. The number 7 indicates that the passord that will follow will be encrypted with type 7.

mpls label protocol ldp

The global mpls label protocol ldp command sets the default label distribution protocol for all interfaces to be LDP.

issu config-sync policy

When two different versions of Cisco IOS images are involved, there is a possibility that the command sets supported by two images might differ. If any of those mismatched commands are executed on the active supervisor engine, the standby supervisor engine might not recognize those commands. This causes a Config Mismatch Condition

The no form of the command removes the defined policy

HTH

Narayan

New Member

Re: clns routing

Wonderful!! thanks for the quick response Narayan

132
Views
0
Helpful
2
Replies
CreatePlease to create content